info:all_electronics_dc-dc_notes
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| info:all_electronics_dc-dc_notes [2008/07/26 23:01] – tomgee | info:all_electronics_dc-dc_notes [2008/07/27 05:36] (current) – tomgee | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== DC-DC comments ===== | ===== DC-DC comments ===== | ||
| - | {{info: | ||
| 1. Output V1 output must have a capacitor even if it's unused. V1 is used on the board as feedback for some regulation of output. | 1. Output V1 output must have a capacitor even if it's unused. V1 is used on the board as feedback for some regulation of output. | ||
| Line 33: | Line 32: | ||
| 5. The output circuits cannot handle any loads that are going to draw much more than a few tens of mA without droop. If you draw 26 mA from the 26VDC output it drops to 24VDC. But this is acceptable for many applications. | 5. The output circuits cannot handle any loads that are going to draw much more than a few tens of mA without droop. If you draw 26 mA from the 26VDC output it drops to 24VDC. But this is acceptable for many applications. | ||
| - | {{info:dc-dc_inverter3200001.jpg?800| }} | + | {{info:dc-dc.jpg|}} |
| + | |||
| + | {{info: | ||
info/all_electronics_dc-dc_notes.1217127719.txt.gz · Last modified: 2008/07/26 23:01 by tomgee