Tom's Life Bits

User Tools

Site Tools

Trace: • router_port_forwarding
info:misc:jacuzzi_pressure_switch_notes

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
info:misc:jacuzzi_pressure_switch_notes [2017/07/04 16:10] – tomgleinfo:misc:jacuzzi_pressure_switch_notes [2017/07/04 16:12] (current) – tomgle
Line 4: Line 4:
   * Pressure switch closes when motor starts.   * Pressure switch closes when motor starts.
  
-  * 1. Locate the Pressure Switch on the back side of the stainless steel Heater Housing. The gray cable from the switch is connected to J3 (Platinum or Primer/Select) or J9 (Duplex).+  - Locate the Pressure Switch on the back side of the stainless steel Heater Housing. The gray cable from the switch is connected to J3 (Platinum or Primer/Select) or J9 (Duplex).
   -  Unplug the pressure switch from the circuit board and with a paperclip or pin knife, push out the two pins from the connector. Clip the leads from an OHM-METER onto these two pins.   -  Unplug the pressure switch from the circuit board and with a paperclip or pin knife, push out the two pins from the connector. Clip the leads from an OHM-METER onto these two pins.
   - With the system "OFF" and no voltage to the Pump/Motor the reading of the OHM-METER should be on "OPEN". If the meter shows the switch as being "CLOSED" adjust the spoked wheel on thenpressure switch counter-clockwise until an "OPEN" condition is read on the OHM-METER.   - With the system "OFF" and no voltage to the Pump/Motor the reading of the OHM-METER should be on "OPEN". If the meter shows the switch as being "CLOSED" adjust the spoked wheel on thenpressure switch counter-clockwise until an "OPEN" condition is read on the OHM-METER.
info/misc/jacuzzi_pressure_switch_notes.1499199045.txt.gz · Last modified: 2017/07/04 16:10 by tomgle