===== TG XB Enviro =====
This Arduino based computer was designed to monitor porch temperature, porch heater, outdoor temperature, greenhouse temperature and greenhouse heater.  The readings will be sent as a packet via Xbee to Meister 2 for display on a web page. Meister 2 will take care of feeding Pachube as well as the web page serving.

RJ45 inputs on TG XB Enviro:

  
  * OW1 4-Porch temp, 6-porch heater, Gnd = 5, 3
  * OW2 4-Greenhouse temp, 6-greenhouse heater. Gnd = 5, 3
  * OW3 4-Outdoor temp & humidity, 6-barometer, Gnd = 5, 3
  * spare RJ45


Twisted pairs in cat 5 =  4 & 5, 6 &3 \\

{{:tgxb_enviro_outline.jpg|}}
  * Currently OW3 & OW4 notused

^Device^Address^data^gnd^OW Jack^Jack Pins^Arduino Bus^
|Porch Tstat|28A3DB9601000076|blue|blue-wh|OW1|4=D, 5=Gnd|7|
|Porch Heater|2853C49601000017|blue|blue-wh|OW1|6=D, 3=Gnd|6|
|GH ambient|28E5A69601000030|blue|blue-wh|OW2|4=D, 5=Gnd|2|
|GH Heater|28DBB996010000DD|blue|blue-wh|OW2|4=D, 3=Gnd|3|
|DHT hum & temp|  | | - |OW3|6=D, 3=Gnd|4|



**Terminal strip 1**
^Source^ ^ ^ Destination ^
|Heat Tstat brown|O|O|Furnace brown|
|Heat Tstat orange|O|O|Furnace orange|
|Heat Tstat OW Data|O|O|Arduino OW2-4 blue|
|Heat Tstat OW gnd|O|O|Arduino OW2-5 blue/wh|
|GH Flue OW Data|O|O|Arduino OW2-6 green|
|GH Flue OW gnd|O|O|Arduino OW2-3 green/wh|

===== Hobby Boards One Wire wiring standard =====
//Note: for reference purposes only//\\


RJ45 jack pin numbers:\\

pin 1 = power return\\
pin 2 = 5V regulated\\
Pin 3 = power return\\
pin 4 = DQ (data)\\
pin 5 = 1 wire return (GND)\\
pin 6 = unconnected \\
pin 7 = unregulated 12v\\
pin 8 = power return\\