Today is another spotty rainy day. Moved some furniture around in the Playroom and laid the base shelf on the floor. This was after I attached wheels. It seems to roll around pretty good. I calculated the height of the support studs and set up outside to cut them. I only had 2 straight boards, the other two were warped. I'll see if I could use them for building more shelves. Went to Home Depot and picked up 4 more new studs. I cut each of 4 studs to 77.5 inches then painted them all blue. Used the remainder of the paint in the roller tray to paint some of the shelves in the plant room until I ran out of paint. Cleaned up and moved on to the Arduino. Hooked up the proto board i built and plugged all the sensors in. The H2O sensor does not work. It reads 85 all the time which gets converted to 185 Fahrenheit. Will probably have to put a scope on the line to figure out what's going wrong. Dinner was potato salad and the leftover rotisserie chicken. Not bad.