Went out in the shop closet and found yesterdays problem of why the breaker blew up when I flipped it. The hot wire in the outlet I mounted had an insulation flaw where it apparently came into contact with the bare ground wire. I used electrical tape to repair it and reassembled everything and flipped the breaker - no pop. Next step was to run Ethernet over to the hub in the garage corner and move the enphase to this new outlet. It was outstanding with 5 bars signal strength to the inverters. Based on this result I ran the conduit pipe across the garage and ran an Ethernet wire inside along with a mason line string for any future wires. The mason line is terminated on each end with a washer holding it from getting lost. Libbie called today from the airport. We chatted a while, i told her about the Labaw person in SC. We both discussed the new swing with Paige in it on Instagram She's only 4 and looks like she is swallowed by the shiny new swing.