Spent the morning on the Yun. After much trial and error, I found that I needed to partition and format the SD card. Next I loaded the treemeasure app into the Arduino and ran the Arduino code which uses bridge to do a simple webserver on the YUN. All html statements are printed out using client.print statements, including the changing water height variable. Some of the issues were I was using the wrong URL and I didn't know how to use API commands. BAsicaly any word you pass in at the end of the URL is your API ekyword. The client code looks for the key word you chose. My url is IP address/arduino/tree
and I look for the command "tree" and do print statements to send back the output. Cut the panel of the hottub to free up the drain into it's own panel. It looks like the tee is leaking. This is about a 1.5 inch pipe. I have some parts to buy. Went to Kroger and found a 7 pound Boston Butt, the only one again. Also picked up some Egg Nogg. Will marinate the park tomorrow in a rub then roast it overnight Monday night.