I spent the morning removing the additional piece of particle board that was a little higher than the adjacent plywood. The plywood I bought yesterday had questionable layers so we hooked up the trailer and brought it back to Home Depot where it was exchanged without any problems. That was good because I did not have the register slip anymore. It turns out I didn't need it, the nice lady at the service desk called a guy over from the lumber department. I drove the trailer from the front door to the lumber door and unloaded the bad plywood and loaded up a better sheet. Libbie and i carried the sheet straight from the trailer to the office floor. I worked on getting it mounted although i had to shim up a corner by the room door. The sheet matches almost perfectly. I only nailed it around the edge because I ran out of nails. We had a dinner of egg salad sandwiches in Pita bread then went out to the studio for the Friday party. I finally mastered FoxTrot!!!! Thanks to Robert's lesson on Wednesday I learned the turning boxes and the zig zag twinkle. We went out to McGregor Tavern after the party. I really enjoyed being outdoors in the patio area. I sat with Terri, Kimber and Jennifer and Nancy and Art. We just met Kimber, a beautiful tall black haired woman who said she has been coming to the studio for a year. We ordered Red Oak beers along with a Quesadilla. The Quesadilla with salasa on it was outstanding. It came with cheese, chicken and jalapenos inside and sides of sour cream and salsa. Loved it. It was a fun night we haven't done in a while.