info:one_wire_temp_conversion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| info:one_wire_temp_conversion [2008/09/20 11:52] – tomgee | info:one_wire_temp_conversion [2008/09/20 11:54] (current) – tomgee | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| In addition, when a conversion is started using parasitic power, the bus must be held high | In addition, when a conversion is started using parasitic power, the bus must be held high | ||
| with a strong pullup. I have been turning the AVR output driver on for this instance. | with a strong pullup. I have been turning the AVR output driver on for this instance. | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| Line 16: | Line 21: | ||
| ===== The Formulas ===== | ===== The Formulas ===== | ||
| - | {{info: | + | |
| + | {{info: | ||
| + | |||
| + | {{info: | ||
| ===== Temperature conversions ===== | ===== Temperature conversions ===== | ||
info/one_wire_temp_conversion.1221925946.txt.gz · Last modified: 2008/09/20 11:52 by tomgee