Differences

This shows you the differences between two versions of the page.

--- toms_moteino-esp8266-wunderground_gateway [2024/06/14 10:08] – created tomgle
+++ toms_moteino-esp8266-wunderground_gateway [2024/06/14 10:44] (current) – tomgle
@@ Line 15: / Line 15: @@
 Steps to program code into the Huzzah:\\
-Put the board into bootload mode. You'll have to do this before each upload. There is no timeout for bootload mode, so you don't have to rush!\\
+Put the board into bootload mode. This needs to be done before each upload. There is no timeout for bootload mode, so there is no rush.\\
   - Hold down the GPIO0 button, the red LED will be lit
@@ Line 23: / Line 23: @@
 Once the ESP board is in bootload mode, upload the sketch via the Arduino IDE\\
+The following image shows the red Moteino with yellow wire antenna, blue Huzzah containing an ESP8266
+and the small blue BME280 Barometric sensor.\\
+{{::pxl_20240614_131815847.jpg|}}