Tom's Life Bits

This is an old revision of the document!

TG XB Enviro

This Arduino based computer was designed to monitor porch temperature, porch heater, outdoor temperature, greenhouse temperature and greenhouse heater. The readings will be sent as a packet via Xbee to Meister 2 for display on a web page. Meister 2 will take care of feeding Pachube as well as the web page serving.

RJ45 inputs on TG XB Enviro:

* OW1 4-Porch temp, 6-porch heater, Gnd = 5, 3
* OW2 4-Greenhouse temp, 6-greenhouse heater. Gnd = 5, 3
* OW3 4-Outdoor temp & humidity, 6-barometer, Gnd = 5, 3
* spare RJ45

Twisted pairs in cat 5 = 4 & 5, 6 &3

Currently OW3 & OW4 notused

Device	Address	data	gnd	OW Jack	Jack Pins	Arduino Bus
Porch Tstat	28A3DB9601000076	blue	blue-wh	OW1	4=D, 5=Gnd	7
Porch Heater	2853C49601000017	blue	blue-wh	OW1	6=D, 3=Gnd	6
GH ambient	28E5A69601000030	blue	blue-wh	OW2	4=D, 5=Gnd	2
GH Heater	28DBB996010000DD	blue	blue-wh	OW2	4=D, 3=Gnd	3
DHT hum & temp			-	OW3	6=D, 3=Gnd	4

Terminal strip 1

Source			Destination
Heat Tstat brown	O	O	Furnace brown
Heat Tstat orange	O	O	Furnace orange
Heat Tstat OW Data	O	O	Arduino OW2-4 blue
Heat Tstat OW gnd	O	O	Arduino OW2-5 blue/wh
GH Flue OW Data	O	O	Arduino OW2-6 green
GH Flue OW gnd	O	O	Arduino OW2-3 green/wh

Hobby Boards One Wire wiring standard

Note: for reference purposes only

RJ45 jack pin numbers:

pin 1 = power return
pin 2 = 5V regulated
Pin 3 = power return
pin 4 = DQ (data)
pin 5 = 1 wire return (GND)
pin 6 = unconnected
pin 7 = unregulated 12v
pin 8 = power return